Six common misunderstandings in decoration see if

2022-07-22
  • Detail

Many partners who are preparing to decorate will know about the decoration matters in advance, some are consulting relevant personnel, some are flipping strategies on the Internet, or buying a book to read. Basically, after a decoration, they have become half an expert. However, even if they consult and understand a lot in advance, there are still many friends who fall into the misunderstanding of decoration. Today, Xiaobian will remind you of the mistakes that owners are prone to make

many partners who are preparing to decorate will know about the decoration matters in advance. Some are consulting relevant personnel, some are flipping strategies on the Internet, or buying a book to read. Basically, after a decoration, they have become half an expert. However, even if they consult and understand a lot in advance, there are still many friends who fall into the misunderstanding of decoration. Today, Xiaobian will remind you of the mistakes that owners are prone to make

first, paint without taste is environmentally friendly products

some people say that the environmental protection standard of paint is without taste. In fact, this statement is wrong. Some paint manufacturers remove the smell of paint by adding spices, which basically smells tasteless. The environmental protection standards of coatings and paints are not smelled by the nose. When choosing coatings and building materials, we should first choose a big brand with reputation and quality assurance, and then we can go to the brand's exclusive stores for on-the-spot investigation. The most important thing is to require businesses to provide formal environmental protection inspection certificates of products

second, the reason for the cracking of the cabinet table is that the material is unqualified

no matter what the material of the cabinet table is, it may cause the cracking of the table joint due to the thermal expansion and contraction of the material. If two different materials are combined, the possibility of cracking is greater. You can reduce the possibility of cracking by adding a layer of lining plate of the same material below the joint, which is the same length as the table top width, and the lining plate width is about 5cm

third, wall cracks are caused by improper construction

improper construction is one of the reasons for wall cracks, but wall cracks may also be caused by other reasons. Deformation of the building itself, such as the sinking of the building foundation; If the indoor temperature and humidity change too much, the wall (body) will crack. The best way to prevent it is to coat kraft paper or gridding cloth before painting, so as to reduce the possibility of wall cracking

fourth, there is a gap in the floor, which is a technical problem of workers

if the indoor temperature and humidity change too much, the floor volume will expand or contract, and a certain gap will be reserved between the floor plates and between the floor and the wall, which can prevent the floor from warping and other deformation caused by expansion. According to relevant national regulations, the expansion joint between the floor and the wall must be between 8-10mm. The size of expansion joints between plates is not regulated by the state, because the floor material is different, its expansion coefficient is different, and the size of expansion joints that need to be reserved is also different. The higher the density of the floor (usually, the higher the density of the floor, the more expensive), the smaller the volume expansion coefficient, so the smaller the reserved expansion joint

fifth, the straight-line laying of water circuits is to increase the number of meters of water circuits and charge more money.

the state clearly stipulates that the laying of water pipes should be horizontal and vertical. Although there is no clear regulation on the laying of circuits, in the industry, the circuit wiring should also comply with the principle of horizontal and vertical in most cases, that is to say, if the water circuit can walk in a straight line, it is best to walk in a straight line. In order to save money, if the circuit wiring is inclined, when it is necessary to nail nails and hang things on the wall in home life, the nails may be nailed to the line, causing potential safety hazards

sixth, the metal frame added around the cabinet door is redundant

generally, only one side of the cabinet door is connected with the cabinet body. Relatively speaking, the cabinet door is in a free state, which is less restrained by external forces, and the deformation coefficient of the wooden cabinet door is large. Therefore, it is necessary to add metal frames around some large wooden cabinet doors to reduce the possibility of deformation. When the height (length) of the wooden cabinet door exceeds 200 cm, or the width exceeds 50 cm, it is recommended to reinforce the wooden cabinet door to reduce the possibility of its deformation. Steel lining can also be added between the door panels of the cabinet door, but if the steel lining is too thin, the effect is not great. Therefore, the best way is to add a metal frame around the cabinet door, but the price of the cabinet door should be doubled or so

decoration is a technical work. Don't think that you will become a decoration expert after asking a few people and reading a few strategies. It's best to hand it over to professional construction personnel. Don't copy the so-called decoration tricks that you hear casually. It's your own house that is being decorated

warm tips: for more practical decoration knowledge and follow-up photos of real scenes on the construction site, please pay attention to your palm (wechat: mall_jia)

成都肿瘤医院

上海精神医院

上海性病医院

重庆精神医院

Copyright © 2011 JIN SHI